About this product
The full-section Adapt-A-Panel inside roof mount for the 2021–2026 4-door Ford Bronco runs from the front windshield back to just behind the front seats, with a full right-to-left panel across the stock upper roof tubes. It bolts to existing mounts with no drilling and works with soft top and hard top, all trim packages.
It turns the roof over the front seats into a mounting surface for radios, GPS units and gear, and ties across the upper tubes to help limit flex.
What Is In The Kit
- 1 windshield-to-rear panel
- 1 windshield adapter mount plate
- 2 overhead side adapter plates
- 1 right-to-left panel section
- 2 L-support brackets for the corners
- 1 full hardware kit
Why A Roof Mount
Cabin space in a Bronco goes fast once radios, GPS units and recovery or camping gear come along, and loose gear ends up on the seats and floor. The area against the roof is mostly unused.
The Adapt-A-Panel system bolts a steel grid to the factory roof tube structure, so that space becomes a strong mounting surface. Mount radios, GPS units, even your hunting gear, and it stays secured on the move and within reach when you need it.
How It Fits Together
Windshield-to-rear section. A full section runs from the front windshield back to just behind the front seats, bolting to the existing mounts at the front.
Right-to-left panel. A full panel spans the cabin from side to side and attaches to the stock Bronco upper tube structures at the existing mounts above. Tying across the upper tubes adds strength there and helps limit flex.
How It Is Built
- Made from .120" thick mild steel
- Grid design with Adapt-A-Panel grid inserts, so you can bolt just about any accessory to the panel system
- Also takes normal MOLLE-type accessories
- Powder coated in a textured black finish so the panels disappear into the headliner and do not attract attention
- Black stainless hardware for a clean look once installed
The product photos show raw material to show the detail of the panels. The kit ships powder coated.
Product protected by US Patent No. 11,940,092 and US Patent No. 12,276,377.
Fitment
Fits the 2021–2026 4-door Ford Bronco (6th Gen), soft top or hard top, all trim packages. No drilling required.
It does not fit the Bronco Raptor, which has its own roof mount kits.
Installation
No drilling required. Pull back the plastic on the front section and bolt the kit to the existing mounts in the front and the existing mounts above in the rear.
Questions
How much of the roof does it cover?
From the front windshield back to just behind the front seats, plus a full right-to-left panel across the cabin.
Does it work with a soft top?
Yes. It works with both soft top and hard top configurations in the 4-door Bronco, all trim packages.
Do I have to drill anything?
No. Pull back the plastic on the front section and bolt it to the existing mounts.
What can I mount to it?
Radios, GPS units, hunting gear and just about any accessory, using the grid inserts. Normal MOLLE-type accessories work too.
Why do the photos show bare metal?
The pictures show raw material to show the detail of the panels. It ships powder coated in textured black.
Is the design patented?
Yes. The product is protected by US Patent No. 11,940,092 and US Patent No. 12,276,377.
Description supplied by Foutz Motorsports through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
