About this product
Three feet of one-inch steel is serious griddle real estate. The Dukers DCGMA36 is aimed at high-output kitchens, from burger bars to busy brunch places, where the plate needs to stay hot even when every inch is covered.
It runs three 30,000 BTU/hr burners for 90,000 BTU/hr in total. The cooking area is 35.83" x 24.02", the unit is 36" wide, 33-1/2" deep and 15-1/4" high, and it weighs about 342 lb.
What you will notice in day-to-day use
- A plate that holds its heat. The 1" thick polished steel plate stores plenty of heat, so the surface bounces back quickly after you load it with cold product.
- Run different temperatures side by side. Independent manual controls every 12" let you keep one section hot for searing and another lower for eggs or holding.
- Pilots stay ready. Each burner has a standby pilot, so the griddle is always ready to come up to heat.
- Less mess at closing. Grease runs into a full-length seamless drip pan that is simple to remove and clean.
- Built to work on any counter. Stainless steel inside and out, with adjustable stainless legs that set the height anywhere from 15-1/4" to 17-5/8" and level it on an uneven surface.
Choosing your setup
Gas type: the griddle ships set up for natural gas, with an LP conversion kit included. Choose the gas your kitchen uses above; the ratings and gas pressures for each are in the table.
Gas Each burner Total input Gas pressure Nozzle Natural gas 30,000 BTU/hr 90,000 BTU/hr 4" W.C. #37 Liquid propane 30,000 BTU/hr 90,000 BTU/hr 10" W.C. #51Specifications
Brand Dukers Model DCGMA36 Type Countertop gas griddle, manual controls Burners 3 x 30,000 BTU/hr, standby pilots Total input 90,000 BTU/hr Controls Independent manual control every 12" Griddle plate 1" thick polished steel Cooking area 35.83" x 24.02" Gas type Ships for natural gas; LP conversion kit included Gas connection 3/4" NPT Construction Stainless steel exterior and interior Legs Adjustable, 15-1/4" – 17-5/8" high Dimensions (W x D x H) 36" x 33-1/2" x 15-1/4" Net weight 342 lb Shipping weight 373 lbBefore it arrives
- Gas: 3/4" NPT inlet; a qualified installer should connect it and fit the LP kit if needed.
- Ventilation: install it under a commercial hood following your local code.
- Counter or stand: 36" wide and 33-1/2" deep, about 342 lb, so use a sturdy, non-combustible counter or stand and keep the clearances in the installation manual.
Warranty
1 year parts and labor from Dukers.
Specifications per Dukers data; subject to change by the manufacturer.
Description supplied by Nishi Enterprise Inc through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.






