Skip to main content

902661A Nordyne Hot Surface Ignitor with Plug

Sold by HVACpartstore

Sponsored
902661A Nordyne Hot Surface Ignitor with Plug
$81.26

Opens hvacpartstore.com in a new tab. The seller handles checkout, shipping, and returns.

We may earn a commission when you buy through product links. Sponsored labels identify paid placements from Shopify. We select the Weekly Edit independently. How we make money

Price and availability requested live for this page. Final details are set by the seller.

Share

A closer fit

Find this, but…

Start with this listing, then change what matters. Matches come live from independent Shopify shops and are separate from StorkScout’s Weekly Edit.

Searches start with new, available products that ship to and from the U.S.

What would suit you better?

Try “folds for air travel” or “same shape, without plastic.”

About this product

902661A Nordyne Hot Surface Ignitor with Plug

Stocking item in our warehouse

Product Overview

902661A is a factory-original Nordyne hot surface ignitor assembly featuring a round silicon nitride element and integrated plug. It serves as both the ignition source and flame sensor in compatible gas furnaces, delivering a rapid warm-up (approximately 15 seconds) and precise flame detection. The kit includes high-temperature leads pre-terminated into a plug and all necessary mounting hardware.


Technical Specifications

  • Element material: Silicon nitride

  • Voltage: 120 VAC

  • Typical current draw: ~2.5 A

  • Warm-up time: ~15 seconds to full glow

  • Active element length: ~3 in

  • Lead length: 9–10 in high-temperature insulated wires

  • Inclusions: Ignitor assembly, plug, mounting bracket, hardware


Cross-Reference Part Numbers

OEM Part Number Replaces / Supersedes 902661A 902661 632140 632202 632250 902379


Compatibility

  • Nordyne and Nortek Global HVAC gas furnace models using spiral/round ignitors

  • Miller and Intertherm MBHA-01 & MMH-05/06/07 series gas furnaces

  • Private-label units requiring a 120 VAC silicon nitride ignitor with plug

  • Always verify against the appliance data plate or service manual before ordering


Technician Notes

  1. Disconnect all electrical power and shut off the gas supply before servicing.

  2. Photograph or label the existing ignitor wiring and bracket orientation.

  3. Handle the silicon nitride element by its ceramic portion—avoid touching the surface.

  4. Remove the old ignitor, clean the mounting surface, and inspect the bracket for damage.

  5. Install the new ignitor in the bracket, ensuring correct alignment and secure hardware torque.

  6. Route and plug in the leads, applying dielectric grease on terminals if desired.

  7. Restore power and initiate a heat call; confirm the element glows within ~15 seconds and that the control board registers flame.

  8. If faults persist, reference the control board’s LED codes and measure ignitor resistance (typically 70–100 Ω at room temperature).


Additional Resources

  • Downloadable OEM installation manual & wiring diagram (PDF)

  • Printable ignitor cross-reference cheat sheet

Nordyne ignitor with plug. Ignitor is 3" long. Wire leads are 9-10" long. Ends of wire fit inside plug. Ignitor glows to light flame on burner. It's also a flame sensor and will send signal to control board to shut down furnace if no flame is detected. Do not touch with bare hands while installing.

Replaces 632140, 632202, 632250, 6322500, 902379 & 902661,  IG1100

Description supplied by HVACpartstore through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.

Keep exploring

Related current listings to open on StorkScout and compare before visiting a seller.