About this product
661135R Nordyne In shot Burner
Normal Stock Item
Product Overview
661135R is a genuine OEM Nordyne inshot burner designed for use in residential and light-commercial gas furnaces. Its compact 3.0 × 4.5 in profile ensures a direct fit in Nordyne, Nortek, and Miller-Nordyne combustion assemblies, delivering a stable flame pattern and reliable ignition performance2.
Technical Specifications
Specifications compiled from Nordyne parts references and OEM data sheets3.
Cross-Reference Part Numbers
The original 661135 was discontinued in October 2022; 661135R supersedes it as the factory-authorized replacement.
Compatibility
661135R fits Nordyne and private-label furnaces built on the CMF95/M7 and MG2 platforms, including (but not limited to):
-
Nordyne CMF95 and M7 series single-stage gas furnaces
-
Nordyne MG2R and MG2S two-stage furnaces (e.g., MG2R072T, MG2S045T, MG2S060F)
-
Miller-Nordyne and Nortek Global HVAC models sharing the same combustion assembly
Always verify against the appliance’s data plate and service manual before ordering.
Technician Notes
-
De-energize all electrical and gas supplies before servicing.
-
Photograph or label manifold orientation and burner bracket location.
-
Remove the old burner; clean the manifold flange and replace the gasket if damaged.
-
Seat the new burner fully against the gasket; tighten mounting screws evenly to OEM torque specs.
-
Restore power and gas, then initiate a heat call.
-
Perform a combustion analysis: verify stable flame pattern (blue cone), proper airflow, and no gas leaks with a leak-detection solution.
-
Adjust the air shutter or orifice as needed to optimize flame characteristics.
Description supplied by HVACpartstore through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.





