WD12X10231 Dishwasher Lower Rack Wheel with Stud for GE - 8 Pack

WD12X10231 Dishwasher Lower Dish Rack Wheel with Stud

Key Features

• Reinforced High-Heat Polymer: Engineered from a specialized industrial plastic designed to endure the extreme thermal cycles of "Power Scrub" and "Heated Dry" settings without cracking or warping.
• Integrated Mounting Stud: Features a built-in heavy-duty axle stud that snaps directly into the lower rack's wire frame, providing a stable, low-friction pivot point for the roller.
• Smooth-Glide Roller Design: The wheel surface is precision-molded to provide a consistent, quiet glide over the tub's track, even when the lower rack is fully loaded with heavy plates and cookware.
• Chemical-Resistant Construction: 100% rust-proof and resistant to the caustic chemicals found in modern dishwasher pods and rinse aids, preventing the wheels from seizing over time.
• Complete 8-Piece Replacement Kit: This value pack provides a full set of replacement rollers for the entire lower rack, ensuring a perfectly level balance and preventing the rack from tipping or jamming.

Replaces / Cross-Reference Part Numbers

• WD12X10231
• 1263942
• AP3994981
• PS1481883
• AH1481883
• EA1481883
• EAP1481883

Compatibility & Fitment

This wheel and stud assembly is the standard replacement for the lower rack of most General Electric manufactured dishwashers. Key compatible brands include:

• GE (General Electric): Fits hundreds of GSD, GDT, GDF, and PDT series models (e.g., GSD2100V, GDT655SSJ).
• Hotpoint: Compatible with various HDA and HDB series budget-friendly dishwashers.
• Kenmore (363 Series): Fits many 363-prefix models produced by GE for Sears.
• Adora & Profile: Direct fit for high-end GE Profile and Adora series tall-tub units.
• Note: Specifically for the Lower Rack. These wheels utilize a "snap-in" stud; verify your rack uses this style rather than a clip-on bracket.

When to Replace

• Rack Dropping Off Track: The lower rack falls into the bottom of the dishwasher tub because the wheels have snapped off or the studs have broken.
• Difficult to Pull Out: The rack feels "stuck" or requires excessive force to move, usually due to flat spots on the wheels or seized internal axles.
• Melting or Distortion: Visible damage from contact with the heating element or long-term heat exposure, causing the wheels to wobble or jam.
• Missing Wheels: Plastic fatigue causes the mounting studs to become brittle and break, leaving the wheels at the bottom of the tub after a cycle.
• Loud Screeching Noise: A high-pitched sound when moving the rack indicates the plastic-on-plastic bearing surface has worn through.

Installation Tips

• No Tools Required: This is a simple "snap-in" repair. Remove the lower rack from the dishwasher and place it on a counter or the floor for easier access.
• Removing the Old Stud: If the old stud is still in the rack wire, use a pair of needle-nose pliers to squeeze the locking tabs and push it out. If it’s broken, simply clear the debris.
• Clean the Wire Frame: Wipe away any old food particles or mineral deposits from the rack wire where the new stud will attach to ensure a secure, permanent lock.
• The "Click" Test: Position the new WD12X10231 wheel against the rack wire and press firmly until you hear a distinct "click." This ensures the locking tabs have fully engaged.
• Check the Track: Before sliding the rack back in, inspect the plastic or metal track inside the dishwasher tub for any obstructions that could damage your new wheels.