About this product
VACQPODS
Take vacuum work holding anywhere you need it. Each hollow-bodied pod holds your workpiece flat and firm using nothing but vacuum — set a pod over a VacQport (pt # VQPT01) and drop your material on, or plug the pod into your vacuum source directly and put holding power on a surface that doesn't have a port at all. Either way, your work is locked down almost instantly and every face stays open.
- Two Ways to Connect - Set a pod directly over a VacQport (pt # VQPT01) and it pulls vacuum straight through — no plumbing, no setup. Or pull the plug and fit the included 1/4" push connector to run the pod off any vacuum source, on any surface.
- Holds Almost Instantly - Lay your workpiece on the pod and vacuum grabs it right away. No clamps, no waiting, no fiddling with hold-downs between pieces.
- Work Every Side - With the pod doing the holding, your material is completely open for routing, chiseling, sanding, planing, or finishing. Nothing in the way of your tool, nothing to work around.
- Sealed Top and Bottom - Each set ships with seal cord for both the top and bottom faces of the pods, so you get a clean seal against your bench and against your workpiece.
- Two Sizes, One Set - A 3" x 11" pod and a 1½" x 10½" pod, both a low 1" tall, cover everything from wide panels to narrow stock — use them individually or together for longer workpieces.
Description supplied by Swan Tool Group through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.






