About this product
Carpet pile only lifts if the brush roller is spinning at full speed, and on the SEBO ET-H head that comes down to this belt. Part 2750 is the brush drive belt for the ET-H, sometimes written ETH, power head.
It is the second stage of a two-belt drive: 2749 carries power from the motor across to the transmission, and 2750 takes it from there to the roller. Knowing which is which saves a wasted order, because a slipping belt at either stage produces the same lazy roller.
- Fits: the SEBO ET-H and ETH power head
- Drives: the brush roller
- Replace when: stretched, cracked or glazed
- Related part: 2749 links the motor to the transmission
- Pack: one belt
- Order as: SEBO part 2750
Belts stretch by degrees, so the loss of cleaning is gradual and easy to miss until a patch of carpet stops looking any different after a pass over it. Look the belt over every few months while you are clearing hair off the roller, and change it as soon as it shows slack, cracking or a glazed face. A belt you can lift far off its pulley with a fingertip has already stretched past its useful tension. Turning the roller by hand while watching the belt shows up a tired one straight away, since it should drive the roller with no slip and no lag.
Keeping a spare in the drawer is sensible on a machine used weekly, because a belt tends to give up in the middle of a job rather than politely at the end of one. Having one on the shelf turns a lost afternoon into a five-minute interruption.
Fitting one is a short job with a screwdriver, and it is worth cleaning the pulley grooves and checking the roller bearing block, part 2751DG, at the same time, since a roller that drags will eat a new belt as quickly as it ate the old one. Searches for a SEBO ET-H brush belt, an ETH power head belt or genuine SEBO 2750 end here.
Description supplied by Vacuums and More through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.






