About this product
The B127 is a single-speed, C-face pool and spa pump motor that bolts to an existing pump's seal plate. It replaces a failed or worn-out motor while keeping the existing wet end, housing, impeller and plumbing.
Key Features
- Permanent split capacitor, switchless design
- Open drip-proof enclosure, auto-reset thermal protection
- 303 stainless steel threaded shaft, ball bearings
- NEMA C aluminum mounting brackets
- UL 1081 design, CSA certified
Compatibility
- Hayward Super Pump, Super II, Northstar and Max-Flo series
- Jacuzzi Magnum, Cygnet, P/PC/EP, PH/UPH and Ring-Lok pumps
- Jandy JHP/JHPU and HHP/HHPU pumps
- Pentair American Eagle and Purex Quietflo/Aquatron pumps
- Waterco HydroStorm and HydroStar, Speck S90/72/EasyFit, Val-Pak/AquaFlo Dominator pumps
- Does not fit square flange wet ends (e.g. 48Y frame square flange pumps)
Compare total horsepower (nameplate HP × service factor) rather than nameplate HP alone when matching to an old motor — this one is labeled 0.75 HP but rated 1.1 THP; fit a new shaft seal at the same time since a worn seal is the most common cause of motor failure.
This is a C-face motor and will not mount to a square flange wet end; no adapter exists.
Description supplied by EZ Pools through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.

