About this product
Product Description
The OSBORN 0001148000 is a crimped stainless steel wheel brush designed for aggressive surface preparation, deburring, cleaning, and finishing on metal and other hard surfaces. It mounts via a 1/4-inch shank and is rated for up to 15,000 RPM, making it compatible with standard die grinders and rotary tools. The 4-inch outside diameter and 1/2-inch face width allow targeted contact on pipes, welds, castings, and fabricated components. The crimped wire fill provides consistent pressure across the work surface, reducing gouging while maintaining good cutting action. This brush is a standard tool for metal fabrication shops, HVAC duct and pipe work, and general mechanical maintenance.
This wheel brush is suited for use on ferrous and non-ferrous metals, stainless steel fabrications, and weld prep or post-weld cleanup applications. It is commonly used by pipefitters, sheet metal workers, maintenance mechanics, and HVAC technicians working on mechanical systems where clean, scale-free metal surfaces are required. The shank mount allows quick installation into any standard collet or chuck that accepts a 1/4-inch shank.
Key Features
- 4-inch outside diameter for broad surface coverage on pipe, plate, and structural shapes
- 1/2-inch face width for controlled, focused brushing action
- Crimped stainless steel wire fill resists corrosion and maintains wire integrity during extended use
- 1/4-inch shank included for direct chuck or collet mounting, no adapter required
- 15,000 RPM maximum rating compatible with most standard die grinders
- Filament wire diameter in the 0.010 to 0.019 inch range for a balance of aggression and surface finish
Compatibility
Designed for use with die grinders and rotary tools accepting a 1/4-inch shank, operating at up to 15,000 RPM. Suitable for metal surface preparation, deburring, and cleaning tasks across fabrication and mechanical service applications.
Installation Notes
A licensed or qualified tradesperson should inspect the brush for damage before each use and verify the tool spindle speed does not exceed the 15,000 RPM rating stamped on the brush. Always power down and disconnect the grinder from its power source before mounting or removing the brush. Secure the shank fully into the collet and tighten according to the tool manufacturer's torque guidelines. Wear appropriate PPE including eye protection and gloves when operating wire brushes at speed.
Technical Specifications
- Outside Diameter: 4 inches
- Face Width: 0.5 inches
- Trim Length: 1.4375 inches
- Shank Diameter: 0.25 inches
- Mount Type: Shank
- Wire Type: Crimped
- Fill Material: Stainless Steel
- Filament Wire Diameter Range: 0.0100 to 0.0199 inches
- Maximum RPM: 15,000
- Shank Included: Yes
- Weight: 10 pounds
Standard Information
- Brand: OSBORN
- Manufacturer Part Number: 0001148000
Description supplied by Voomi Supply through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
