About this product
If you are having clearance issues with your steering then our offset tie rod end (OS2234R) may just be what the doctor ordered this will offset your tie rod 1". This is a right hand thread offset tie rod end that is based of from the legendary GM 1 ton tie rod end, it shares the same taper (7° or 1.5" per ft.) and will fit most dana 60 front axles. These are sold individually. Thread shank size is 7/8-18. The threaded stud is 5/8 -18 with a taper of 7°, and we include a jam nut with them.
These tie rods will arrived pre-greased. No additional grease will be required. If too much grease is applied it will be pushed out around the top and bottom of the rubber boot. This has the chance of causing the boot to tear as well. When using these rod ends in your steering set up, it is recommended to apply one pump of grease, per joint, every other oil change or every 12,000 miles.
Description supplied by Barnes 4WD through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
