About this product
If your setup changes, your gear should adapt with you. When running a zero-offset wheel, aftermarket tire carrier, deep-dish rim, or a spare that sits farther outward, higher, or lower than factory position, your load handler may need additional height to mount correctly. The rucRak Load Handler Pedestal Extensions add a clean, solid 2 inches of vertical lift—restoring the alignment, stability, and proper mounting zone required for safe, reliable performance.
NOTE: If you have an aftermarket tire carrier or a positive offset on your wheel, measure from the pin hole in your hitch to a virtual vertical line on the outside of your tire as shown in the mage below noting <14".
If that measurement is MORE than 14”, then you will need to add these to your order.
Each set includes two precision-machined, heavy-duty, corrosion-resistant steel pedestals engineered to maintain structural integrity and load balance across daily driving, highway travel, and off-road terrain. Whether you’re dialing in a custom wheel setup or compensating for a modified carrier, these extensions ensure your load handler sits firm, level, centered, and adventure-ready.
Description supplied by rucRak through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
