About this product
The Motobilt Jeep JK Hatchet Rear Frame Chop Bumper allows for 5 inches of additional ground clearance over the factory receiver hitch. The additional ground clearance you gain is the same as going from a 35 inch tire to a 40 inch.
Fits:
Jeep JK & JKU Wrangler 2007 to 2018
Specifications
- 3/16 inch Laser cut and CNC bent steel body
- 3/4 inch Thick laser cut D-Rings that pass through the bumper and welded inside and out
- Gain 2 3/8 inches up and 3 3/8 inches back of ground clearance
- 5 inches of additional clearance over the factory receiver hitch
- Ultra tight design allows the use of a large spare tire
- Full protection from corner to corner
- Includes high strength cross member
- Cross member bolts into factory body mounts then must be welded to the frame
- Works with factory frame or Motobilt jeep JK back half kit
- Cross member includes pre-installed threaded inserts for mounting Motobilt Hatchet JK frame chop rear bumper
- Threaded mounting holes for JK rear fuel cell skid plate also included
-
Ships raw steel. Must be painted or powder coated to prevent rust. See (Steel-It)
- Installation video can be found under the Instructions tab
- Includes necessary hardware
- Weight: 80lbs (approx.)
Notes:
- Requires cutting of rear frame rails and removal of factory rear cross member
- Cross member must be welded to frame rails.
- A receiver hitch will NOT work with this bumper.
Instructions
Description supplied by Motobilt through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
