About this product
DirtyBike Hard Enduro Skid Plate Cooling Vent Hole Plug kit for Muddy Conditions
Dial in your DirtyBike Ultra Bee skid plate ventilation to meet your exact needs
These simple "push in" plugs are used to reduce debris accumulation when maximum cooling is not necessary.
In muddy, or wet conditions, where maximum cooling is not required. These individual hole plugs can be installed in any configuration to balance cooling and protection and prevent unwanted debris for getting to your motor or wires.
- Tough and flexible thermoplastic material
- Pushes in from one side
- Reduces mud and debris entering
- Easy to install and remove
Note: Push the plug in deeper than flush to engage the lip in the hole.
Warning: Plugging too many vent holes can cause the motor temperature to increase prematurely!
Check out our Ultra Bee skid plates here: Ultra Bee Skid Plate
Description supplied by eDirtyBike through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
