About this product
About This Socket - P125
Add this polyethylene caster socket to a 1-inch, 18-gauge round tube leg (0.902-inch inside diameter) so a 7/16-inch grip-ring stem caster can drop straight in, where the tube has no receiver for a caster stem.
The socket presses into the open end of the tube and holds the 7/16-inch friction-grip stem of a Faultless ER or EW series caster, turning a fixed round-tube base into a rolling one without welding or a bolt-on plate. It needs a minimum hole depth of 1.812 inches inside the tube, so it suits shorter tube ends than the 2.125-inch depth a reinforced thermoplastic socket needs. Measure your tube's inside diameter before ordering: the socket must press in tight to hold under load.
Specifications
- Tube: 1-inch OD round, 18 gauge
- Tube inside diameter: 0.902 inch
- Minimum hole depth: 1.812 inches
- Material: polyethylene
- Stem: 7/16-inch grip ring (Faultless ER and EW series)
Ideal applications
- Round tube legs measuring 0.902 inches inside diameter
- Tube ends too short for a 2.125-inch-deep socket
- Chairs, tables, and light frames converted to rolling bases
If the tube measures smaller or larger, see the 0.872-inch RT123RD or the 1.072-inch RT126RD, matched to your tube.
Pairs with: a 7/16-inch grip-ring stem caster. See the Faultless collection.
Wrong fit? Need a stiffer socket for the same tube and have 2.125 inches of depth? The reinforced thermoplastic RT125RD fits the same 0.902-inch tube.
Also in this family: every round and square tube socket in Caster Sockets and Brackets.
Description supplied by Caster Central through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.
