About this product
Product Description
The CARRIER LH680014 is an L-Bend flame sensor with lead wire, designed for use in gas furnaces where the control board monitors burner flame presence. The sensor element detects the rectified microamp signal produced by a standing flame, allowing the furnace control to confirm ignition and hold the gas valve open. Element total length is 3 inches, with a bracket length of 0.875 inches and a lead length of 4.625 inches. This is an OEM-replacement component manufactured in the USA. Note: this part has been superseded by part number LH680534, which is the current replacement.
This flame sensor is used in residential gas furnaces across the Carrier, Bryant, and Payne equipment families. It is installed in the burner compartment, where the sensor rod extends into the burner flame path and the bracket mounts to the burner assembly. The included lead wire connects to the furnace control board. Technicians replacing a faulty or contaminated sensor as part of a no-heat diagnostic will find this a direct OEM-style fit for applicable models.
Key Features
- L-Bend element style for correct burner-compartment positioning
- Total element length of 3 inches with distance to L-bend at 1.25 inches
- Includes pre-attached lead wire at 4.625 inches for direct control board connection
- Bracket length of 0.875 inches for standard burner assembly mounting
- Manufactured in the USA as a factory-authorized replacement component
- Supersedes legacy Carrier part numbers LH33WZ517, LH680012, LH33WZ511, and LH33WZ515
Compatibility
Fits Carrier, Bryant, and Payne furnace models. Replaces Carrier part numbers LH33WZ517, LH680012, LH33WZ511, and LH33WZ515. This part has been superseded by LH680534 as the current active replacement.
Installation Notes
Flame sensor replacement is performed by licensed HVAC technicians. Always shut off power to the furnace at the disconnect and turn off the gas supply before beginning work. The sensor rod must be positioned correctly within the burner flame envelope to allow proper microamp signal generation - do not bend or alter the rod angle. Clean the mounting surface and inspect the lead wire connection at the control board for secure termination before restoring power.
Technical Specifications
- Style: L-Bend
- Total Length of Element: 3 inches
- Distance to L: 1.25 inches
- Distance to End: 1.75 inches
- Bracket Length: 0.875 inches
- Lead Length: 4.625 inches
- Weight: 0.65 pounds
- Country of Origin: USA
- Superseded By: LH680534
Standard Information
- Brand: CARRIER
- Manufacturer Part Number: LH680014
Description supplied by Voomi Supply through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.






