Baileigh RDB-325 Programmable Pipe Bender

Baileigh RDB-325 Programmable Pipe & Tube Bender — 2" Schedule 80 Capacity, 170-Program Memory

The RDB-325 is a fully programmable rotary draw bender built for shops producing the same bend, or the same multi-bend part, over and over. You program each bend — angle, springback allowance, and material rotation — on the touchscreen, and the machine reproduces it off the foot pedal. It stores up to 170 programs of 10 bends each, so a job you ran last month comes back exactly as you set it.

Capacity covers 2" schedule 80 pipe and 3" round tube — mild steel and stainless to .095" wall, chromoly to .083", aluminum to .203" — with a maximum 16.5" centerline radius. Rotary draw means a matched bend die and counter die pull the material around a fixed radius — the clean, repeatable method for roll cages, headers, handrail, and chassis work where every bend has to match the print. Baileigh offers a deep range of dies across diameters and CLRs, so the machine grows with the work.

The 1,100 lb welded steel frame is what makes the repeatability hold — mass and rigidity keep the geometry from walking across a production run. It runs on 220V single-phase power, so it drops into most fabrication shops without a three-phase service. A 180° bend takes about 9 seconds; the control will take it to 205° with the right tooling. The RDB-325 is made in the USA and backed by Baileigh's 1-year parts warranty and lifetime phone tech support.

The RDB-325 takes Baileigh's rotary draw tube dies and pipe dies — match the die to the diameter and centerline radius you're bending. To compare it against the rest of the range, see the pipe & tube benders collection.