About this product
902128 Nordyne 5-5/8″ Blower Motor – 1/2 HP, 115 V, 4-Speed
Product Overview
902128 is a genuine OEM Nordyne indoor blower motor engineered for residential air handlers and furnaces. This robust PSC motor delivers 1/2 HP at 115 VAC across four selectable speeds to match airflow requirements, ensuring quiet, reliable operation and compatibility with a 5-5/8″ diameter blower wheel assembly.
Technical Specifications
Cross-Reference Part Numbers
-
OEM Nordyne: 902128
-
Nordyne Catalog: 01-0084
No superseded or alternate numbers documented; use 902128 for direct factory replacement.
Compatibility
-
Fits Nordyne and Nordyne-Miller indoor air handlers and furnaces originally equipped with a 5-5/8″ blower wheel and 1/2 HP PSC motor
-
Direct swap for private-label and OEM models requiring a 4-speed, 115 VAC blower motor with CCWLE rotation
-
Always confirm blower wheel diameter, frame size, shaft length, and rotation against the appliance data plate before ordering
Technician Notes
-
De-energize power; lock out/tag out per safety procedures.
-
Remove blower compartment or furnace access panel.
-
Label and disconnect all motor leads from the wiring harness or terminal block.
-
Loosen belt tension (if belt-drive) or set-screws (direct-drive) and remove the old motor.
-
Mount the new 902128 motor—align the frame, retension the belt or engage the direct-drive coupling, and torque set-screws to OEM specs.
-
Reconnect motor leads according to the speed-tapping diagram; ensure secure, corrosion-free connections.
-
Restore power and cycle through each speed; listen for smooth, vibration-free operation and verify airflow at each setting.
-
Inspect mounting grommets or springs and replace if worn to minimize noise and vibration.
Blower Motor, 4 speed, 1/2 hp, 7.9 amps, 115V, 1075RPM. CCWLE rotation (counter clockwise lead end). 5-5/8" diameter x 5" deep. Shaft size 1/2" x 4.5". Includes 6-pin male molex plug. Used on M2 & M3 furnace series.
Note: The M3 furnaces were shipped with motors with 2 different mounting brackets. Measure the mounting distance. If the distance is around 11", then you may need the 903433 motor.
Requires a 10MFD/370V run capacitor PRCF10A (not included).
Wiring: red low, orange med-low, blue med-high, black high, white common, browns run cap.
Replaces 621324, 621895, 621999, 622014 & 903808.
Description supplied by HVACpartstore through its current Shopify listing. Product, performance, and health claims are the seller’s and have not been independently verified by StorkScout.


